Engine
Aftermarket Assassins Polaris General / Ranger Catch Can Engine Engine
Polaris General / Ranger Catch Can
Kubota UTV parts online,Our Ranger / General Catch can is a must-have for those increasing boost with a turbocharger kit! As boost pressure increases, crankcase pressure also increases. The extra boost also increases airflow through your intake tube, and creates a straw effect on the stock crankcase vent (which is routed into the intake tube). Running oil into your turbo, yamaha utv parts canada, utv parts manufacturer, charge tube, intercooler, 2002 polaris utv parts, utv aftermarket parts, camso utv trail parts and engine is not something ideal. This trap can eliminate that and does a much better job than commercially available cans. This latch is fully welded with a 1" port and has a 1" air filter ID. A big problem with other capture boxes is that they use NTPor other fittings that have a very small ID, camso utv 4s1 track parts and a very small air filter ID. This restricts flow, which creates more pressure in the crankcase...not good!
Rangers are notorious for soaking the air filter with oil due to excessive torque limits closing the throttle at high loads, which causes a rapid vacuum that draws oil from the crankcase. A latch eliminates the problem of exposing the air filter to oil.
We found that the Ranger/General really likes to push oil out of the crankcase breather into the intake tract under pressure. This device can significantly reduce the amount of oil/fuel vapor present in your intake and is almost a must have modification for those with a turbo kit.
We found that the pressure was too high during long periods of time. (a sustained WOT operates with high thrust) littlet move the oil away from the lower end and cause connecting rod bearing failure. This mostly happens during races or extremely aggressive riders who keep it stuck without much downtime for the oil to return to the bottom end.
Easy installation and mounts securely to the rear of the cabin (next to the ECU). on Ranger models). This can easily be mounted elsewhere if you have a bed delete or custom setup.
Features:
- Removes excess oil vapor from your oil collector intake
- Helps eliminate excess oil vapor octane reduction in your intake during aggressive driving - when it matters most
- Helps reduce buildup of carbon on the pistons, valves, Yanmar UTV parts and combustion chamber
- All welded construction and made in the USA!
- High die air filter1" ID bit (image currently shows a prototype with a 2" filter)
- High flow welded aluminum port for maximum pressure relief
- The aluminum body 3" aluminum can holds a large volume of oil
- Baffle design with fuel foam to prevent oil from splashing out of the can
NOTE: L The image shows a prototype capture box with 2" filter. Standard production capture device uses a 1" filter.
VEHICLE FITMENT- Polaris General 1000
- Polaris General XP 1000
- Polaris Ranger XP 1000
