Engine
Aftermarket Assassins Polaris RZR Pro XP / Turbo R Fuel Pump Assembly with High Flow Pump Engine Engine
Polaris RZR Pro XP / Turbo R Fuel Pump Assembly with High Flow Pump
utv parts near me,High pressure for high fuel demand with our 255 liters per hour pump is perfect for stock vehicles and a great complement for modified vehicles to prevent pressure drops.
/p>
OEM and our pumps are pressure regulated with an internal housing regulator. Our pump is equipped with the correct, high quality regulator for the Pro XP / Turbo R, as these models use higher fuel pressure than most other Polaris models.
Weak fuel pumps show Normally a loss of peak power/RPM at wide open throttle. As they get worse, you may also experience low and mid range stumbles. Keep in mind that sometimes bad fuel pumps send or allow debris to reach the fuel injector inlet strainer and the injectors may also need cleaningor replaced.
This pump has a simple design without a fuel bucket. Some OEM pump designs for this model have a fuel bucket that fills from an external filter. The idea behind the bucket design is to reduce fuel flow by filling a smaller space around the pump. This design is complicated and more difficult to work with. Since the filter sits vertically in the tank, Polaris UTV Parts, UTV Definition, UTV Parts Guy Discount Code, Rockauto UTV Parts, Arctic Cat UTV Parts, this also means it will run out of fuel before a no bucket style design. That's why we go with Bucketless Parts, eBay Polaris UTV, Traditional Style Design.
For proper installation procedure, please refer to your service manual. Installation is easy on these models since the fuel tank sits sous the passenger seat (or rear passenger for 4-seater models). Most models must remove the quick connect firewall panels (1/4 turn fasteners) to access the pump. You can then remove the fuel pump retaining ring with our tool or a screwdriver/hammer.
You will need to install the supplied 15A fuse in place of the 10A OEM EFI fuse. Consult our fuel cap. Removal tool for easy removal and installation of fuel tank retaining ring.
Features:
- Complete pump assembly is ready to remove in the tank
- Depending on the year, Pro XP models have a few different fuel tank designs. We have verified that our pump fits and works well in all models and fuel tanks.
- The very high quality fuel pump is compatible with ethanol blended fuels up to E -85.
- The OEM Pump works well with E85, Coleman UTV 400 parts, but its life is limited.
- Great replacement if you think/know your factory pump is low or your current pump is not working.
- The pump housing is assembled in the AA factory in the United States
NOTES:
- We strongly suggest using a flashlight to look into the tank with the original manufacturer. pump removed.
- Make sure there is no debris in the tank that could cause the new pump to fail and clean the tank if necessary.
- Polaris RZR Pro XP
- Polaris RZR Turbo R
