Engine
Aftermarket Assassins Polaris Xpedition Fuel Pump Assembly with High Flow Pump Engine Engine
Polaris Xpedition Fuel Pump Assembly with High Flow Pump
The complete pump assembly is ready to drop into the tank
The pump housing is assembled in the AA factory in the United States
The pump Very high quality fuel is compatible with ethanol blended fuels. to E-85
High pressure for high fuel demand with our 255 liters per hour pump
The original manufacturer and our pump are pressure regulated with a pressure regulator internal housing. Our pump is equipped with the correct, high quality regulator for the Xpedition.
Great replacement if you think/know your factory pump is weak or your current pump is not working
Weak fuel pumps normally show a loss of peak power/RPM at full throttle. As they get worse, you may also experience low and mid range stumbles. Keep in mind that sometimes faulty fuel pumps send or allow debris to flow into the vehicle.remove the fuel injector inlet strainer and the injectors may also need to be cleaned or replaced.
We strongly suggest using a flashlight to look into the tank with OEM pump. deleted. Make sure there is no debris in the tank that could cause the new pump to fail and clean the tank if necessary.
This can be installed in a stock or modified vehicle.
This pump has a simple design without a fuel bucket. The OEM pump has a fuel bucket that fills from an external filter. The idea behind the bucket design is to reduce fuel by filling a smaller space around the pump. This design is complicated and more difficult to work with. Â Since the filter sits vertically in the tank, kawasaki utv parts, armadillo utv 4s spare parts, mahindra utv parts, utv parts in gros, this also means it will run out of fuel before a bucketless design. That's why we go with Tusk UTV parts without bucket, traditional style design.
Just for information, UTV accessories near me, UTV parts Jacksonville, our Xpedition store had an outage fuel pump at 2,500 miles. The vehicle began to malfunction during a trip and then went into a no-start condition. No signs of excess debris in the tank, yamaha rhino 450 utv parts, it was a simple pump failure.
Installation is very simple. For the proper installation procedure, please refer to the service manual. The fuel pump is accessed by removing the passenger seat and removing the plastic cover. You can then remove the fuel pump retaining ring with our tool, Kymco UTV parts or a screwdriver/hammer. You will also need to install the fusi15A ble supplied in place of the OEM 10A EFI fuse.
Check out our fuel cap removal tool to easily remove and install the fuel tank retaining ring.
VEHICLE LAYOUTPolaris Xpedition
C16240210 discountable, Make_Polaris, Model_Xpedition Fuel Cap Removal Tool:No Fuel Cap Removal Tool,Add Fuel Cap Removal Tool4.85 (371 reviews)
