Body
Wolfsnout Polaris RZR Pro R Cool Cab Kit / Rear Seat Heat Shield Body Body
Polaris RZR Pro R Cool Cab Kit / Back Seat Heat Shield
Wolfsnout Cooler Cab Kit for RZR Pro R. We all feel the heat. It's sometimes unbearable in summer. Nice to have in winter. This kit seals and insulates the console of your Polaris Pro R by diverting hot air from entering the cabin through the tunnel. Foam insulation with a radiant barrier, Fast UTV Parts, Parts Online, Used UTV Parts Nebraska, UTV Windshields and Accessories and a rubber gasket to stop hot air. No more hot gear lever and console. Drinks stay cold! Also check out our Front Fender and Dash Seal Kit, Rear Firewall Insulator and Sound Seal for added Cool Cab™ comfort.
It's our solution. This is an aluminum foil insulating soundproofing material that we hot laminated to a rubber backing with mylar bubble insulation in between for high insulation capacity. It is then cut, sewn to be installed on the full rear panel, not only to insulate but also to stop the hot air that is sucked in from the rear when using full windshields.
Not only does it block rear heat and significantly reduces engine noise in the cabin. You can remove it in winter to recover your heating. If using harnesses we also offer rubber harness grommets to close the heater vents where the harnesses are attached. They also give a finished look.
VEHICLE INSTALLATIONPolaris RZR Pro R
INSTALLATIONPRO R REAR SEAT HEAT SHIELD INSTALLATION
Be sure to clean all areas with alcohol. .
If you put silicone on it, you may need to clean it with acetone.
- Slide the mat behind the harnesses
- Center mat on console.
- Place the bottom of the mat in the same slot qui holds the lower rear panel.
- Slide the mat behind the console.
- Form mat to fit the curves of the rear panels.
- Make sure that the top is aligned with the harness brackets.
- Fold the edges on both sides around the engine compartment.
- Starting at the top in the middle, peel off the Velcro dots and reheat the sticky side with a hair dryer or heat gun,
- Then attach the Velcro dot to the top of the fire wall cover, while remaining in place on the back mat.
- Go around from the middle. take out, parts lz150-1 utv, warming and adhering the Velcro, while still attached to the mat.
- Repeat on the sides.
