Switches
XTC Power Products Can Am Maverick R/X3 6-Switch Power Control System with Strobe Lights Switch Switches Switches
Can Am Maverick R / X3 6 Switch Power Control System with Strobe Lights Switch
UTV Accessories Financing,XTC Power Products is leading the way in UTV wiring. Powering multiple accessories has become easier than ever with our Plug and Play PCS (Power Control System) for the Polaris Can-Am Maverick X3 with Strobe System. Unlike other available switch systems, UTV parts and accessories, the Power Control System is designed with the installer in mind. Each PCS has a vehicle-specific power connector and rocker switch harness that fits the factory pre-cut rocker switch positions.
Power Delivered
The PCS-72S-MAV includes 1 x 30 amps. and 1 x 20A high current circuits on relay with diode protection. The design reduces voltage spikes due to field collapse, protecting LED lights and other sensitive accessories. There are also wire circuitsdirect 3 x 10 amps supplied for low consumption accessories such as rock lamps or whip lamps. One Switch is a dedicated strobe light system with 2 channels on a 10 amp fuse. Also included is a fuse block that protects the circuits and comes with an eight-gauge power cable and fuses. Most UTV charging systems produce between 40 and 70 amps. For this reason, a 50 amp circuit breaker at the battery safely powers the PCS. Installing a high power switching system over 100 amps is not practical in a UTV.
The barrier strip of power control systems
The Professional wiring installers use barrier strips in off-road vehicle constructions. for years. Some good reasons would be aesthetics, as well as ease of use when adding new connections andfurther troubleshooting. Each screw point on the barrier strip has a different colored wire that matches the wires in the fuse box harness and switches. Therefore, the first toggle switch would be the large gray 30 amp wire, Textron UTV parts, and so on. Finally, the purple and yellow wires are the strobe system circuits and strobe in a left/right sequence when activated.
Can-Am MaveRick Strobe System Switch Power Harness Configurations X3
Designed for the Can-Am Maverick X3, the PCS-72S-MAV switch harness features three toggle switch positions that mount in the center console between the driver and passenger. Additionally, Bobcat 3200 UTV Parts Diagram, Auto Palace Parts, Two toggle switches mounted in the center dash and one final switch that can be mounted next to the steering wheel or the center dashal. Additionally, toggle switches can also be installed together in any custom manner deemed appropriate by the installer. The strobe system has 7 different flashing modes that can be activated using the included black mountable switch. Additionally, a Molex connector connects the switching harness to the main power control system.
Modular power connection
The PCS-72S-MAV has a connector Modular power supply at fuse box with +/- ring terminals that connect to ignition power. Therefore, the bottom LED (available on custom rocker switches) will only illuminate when the ignition key is turned on. The top light only turns on when the toggle switch is pressed. It should be noted that the wiring system will work with or without the vehicle's ignition.
*The PCS-72S-MAV comes with 5 intCarling V series toggle switches with incandescent lighting feature an actuator with a red lens and 1 toggle switch illuminated by LED strobe lights. Alternatively, the PCS-72-NS ONLY comes with a toggle switch for strobe lights, and no other switches. Custom LED illuminated rocker switches are available separately and can be found on our rocker switches page. 6 Switches, Rad UTV Parts Reviews, One switch included with red LED strobe toggle
- Can Am Maverick R
- Can Am Maverick X3
